line of products is discontinued. We are still selling some of them
while supply last but please check Prices
section for availability before ordering. Check this
link for possible metric substitutes.
plates -- Mounting
Posts --Mounting Post Lock Ring --
Holders -- Spacer --Right Angle Connector
--Flat and Angle connectors--Bench
Unlike optomechanical components manufactured by other
companies ours are made from non-anodized aluminum. Electrical resistance
between connected non-anodized aluminum parts is very low. This make
our components perfect for use in systems for sensitive electrical measurements.
You do not have to drill holes in or scratch all parts in a complex system
to have them electrically connected for proper grounding. We guaranty that
when parts are connected mechanically, they are connected electrically.
If you need black non-reflecting surfaces simply apply black spray enamel
on the assembled system.
breadboard mounting plates.
This 1/8" thick aluminum mounting
plates are available in two sizes 3"x5", and 5"x7". Each have 15
(SP-35) 6.5 mm
diameter holes on a 1" square pattern.
Manufactured from high quality aluminum our Bench Plates
provide solid base for various configuration of components.
Each plate have a number of 1/4" (6.25 mm) threaded holes on a square pattern
with 1" (25.4 mm) distance between centers and 1" from sides of the plate.
metric plates (25 mm square pattern, M6x1.0 thread) can be manufactured
at your request.
||# of holes
These lightweight durable mounting posts mounts directly,
or with Post Holder to any standard optical
table/bench plate using ¼-20 tpi threaded set
Post Lock Ring
This aluminum lock ring fits all
1/2" diameter mounting posts. When ring is locked, the post can be
rotated in the post holder without readjusting height. 1/4-20 tpi
thumb screw included.
Part #: PLR-1
These post holders accept any standard 0.5" (12.6 mm)
diameter mounting posts. Aluminum. Lock screw for post height ajustment
and Allen screw for mounting to an optical plate are included.
This simple component is a useful addition to a family
of 1/2" diameter mounting hardware. It is actually a thick wall aluminum
tube that can be used as 25 mm high mounting post or as whatever you can
Part #: S-25
Angle Connector 
This connector is used for 90 degree mounting of standard
0.5" mounting posts. 1/4-20 tpi thumb
screws are included. Aluminum.
Plate Clamp 
This clamp allow to position any base mounted component
anywhere on an optical table or bench plate. Extra heavy duty design;
milled from steel. Black finish. Part#: BC-75.
and Angle connectors.
These simple but useful parts complement our line of
optical bench products. Available in different lengthes. Each connector
have a number of 7 mm diameter holes 1 inch apart. (FC-1 & AC-1
have one additional D-6.5 mm hole in the middle). Aluminum.
|Number of holes
|Width & Thickness
||1" x 1/4"
|Number of holes
Back to the top of the page.
Date of latest modification: 11-16-2010